📚 Exam by Category
▾
Objective Questions

Latest Trade Apprentice Welder, electronics & Communication Trade Exam Question (Objective Questions), MCQ in English

Subjects : Welder, Electronics & Communication

Question Bank Trade Apprentice Welder, Electronics & Communication Exam - English
Back to Exam

Welder, Electronics & Communication

Question 1Single Answer
At temperature of 298 Kelvin, Silicon is not suitable for most-electronic applications, due to small amount of conductivity. This can be altered by
  1. A
    Gettering
  2. B
    Doping
  3. C
    Squeezing
  4. D
    Sintering
Question 2Single Answer
By doping Germanium with Gallium, the types of semi-conductors formed are
1. N type
2. P type
3. Intrinsic
4. Extrinsic
  1. A
    1 and 4
  2. B
    2 and 4
  3. C
    1 and 3
  4. D
    2 and 3
Question 3Single Answer
An n-type of silicon can be formed by adding impurity of:
1. Phosphorous
2. Arsenic
3. Boron
4. Aluminum 
Which of the above are correct ?
  1. A
    1 and 2
  2. B
    2 and 3
  3. C
    3 and 4
  4. D
    1 and 4
Question 4Single Answer
According to Einstein’s relationship for a semiconductor, the ratio of diffusion constant to the mobility of the charge carriers is
  1. A
    Variable and is twice the volt equivalent of the temperature
  2. B
    Constant and is equal to the volt equivalent of the temperature
  3. C
    Equal to two and is twice the volt equivalent of the temperature
  4. D
    Equal to one and is equal to the volt equivalent of the temperature
Question 5Single Answer
Swept-out voltage in PIN diode happens when PIN diode is
  1. A
    Forward biased and the thickness of the depletion layer decreases till I-region becomes free of mobile carriers
  2. B
    Reverse biased and the thickness of the depletion layer increases till I-region becomes free of mobile carriers
  3. C
    Forward biased and the thickness of the depletion layer increases till I-region becomes free of mobile carriers
  4. D
    Reverse biased and the thickness of the depletion layer decreases till I-region becomes free of mobile carriers
Question 6Single Answer
The number of holes in an N-type silicon with intrinsic value 1.5 × 1010/cm3 and doping concentration of 1017/cm3, by using mass-action law is
  1. A
    6.67 × 106/cc
  2. B
    4.44 × 10-25/cc
  3. C
    1.5× 10-24/cc
  4. D
    2.25 × 103/cc
Question 7Single Answer
A tunnel-diode is best suited for
  1. A
    Very low frequencies
  2. B
    50 Hz
  3. C
    100 Hz
  4. D
    Microwave frequencies
Question 8Single Answer
Small recovery time of a diode is most significant for
  1. A
    Line-frequency rectification
  2. B
    Switching operations
  3. C
    High-frequency rectifications and switching operations
  4. D
    Low-frequency rectifications and switching operations
Question 9Single Answer
In JFET, when operated above the pinch-off voltage, the
  1. A
    Depletion region becomes smaller
  2. B
    Drain current starts decreasing
  3. C
    Drain current remains practically constant
  4. D
    Drain current increases steeply
Question 10Single Answer
Thermal runaway is not possible in FET because, as the temperature of FET increases
  1. A
    The drain current increases
  2. B
    The mobility of charge carriers decreases
  3. C
    The mobility of charge carriers increases
  4. D
    The transconductance increases
Question 11Single Answer
Which one of the following helps experimental confirmation of the Crystalline state of matter?
  1. A
    Shock compression
  2. B
    Photo emission
  3. C
    Conductivity measurements
  4. D
    X-ray diffraction
Question 12Single Answer
The electrical conductivity of pure semiconductor is:
  1. A
    Proportional to temperature
  2. B
    Increases exponentially with temperature
  3. C
    Decreases exponentially with temperature
  4. D
    Not altered with temperature
Question 13Single Answer
Consider the following statements pertaining to the resistance of a conductor:
1. Resistance can be simply defined as the ratio of voltage across the conductor to the current through the conductor. This is, in fact, Georg Ohm’s law.
2. Resistance is a function of voltage and current.
3. Resistance is a function of conductor geometry and its conductivity
Which of the above statements are correct?
  1. A
    1 and 2 only
  2. B
    2 and 3 only
  3. C
    1 and 3 only
  4. D
    1, 2 and 3
Question 14Single Answer
The ratio of ionic radii of Cations i.e.and that of Anions i.e.for stable and unstable ceramic crystal structure, is:
  1. A
    Less than unity
  2. B
    Greater than unity
  3. C
    Unity
  4. D
    Either lesser or greater than unity
Question 15Single Answer
Which one of the following statements is correct?
  1. A
    For insulators the band-gap is narrow as compared to semiconductors
  2. B
    For insulators the band-gap is relatively wide whereas for semiconductors it is narrow
  3. C
    The band-gap is narrow in width for both the insulators and conductors
  4. D
    The band-gap is equally wide for both conductors and semiconductors
Question 16Single Answer
Which of the following regions of operation are mainly responsible for heating of the transistor under switching operation?
1. Saturation region
2. Cut-off region
3. Transition from saturation to cut-off
4. Transition from cut-off to saturation
Select the correct answer using the codes given below
  1. A
    1, 2 and 4 only
  2. B
    1, 3 and 4 only
  3. C
    2 and 3 only
  4. D
    1 and 3 only
Question 17Single Answer
In a sinusoidal oscillator, sustained oscillations will be produced only if the loop gain (at the oscillation frequency) is
  1. A
    Less than unity but not zero
  2. B
    Zero
  3. C
    Unity
  4. D
    Greater than unity
Question 18Single Answer
The Class-B push-pull amplifier is an efficient two –transistor circuit, in which the two transistors operate in the following way:
  1. A
    Both transistors operate in the active region throughout the negative ac cycle
  2. B
    Both transistors operate in the active region for more than half-cycle but less than a whole cycle
  3. C
    One transistor conducts during the positive half-cycle and the other during the negative half-cycle
  4. D
    Full supply voltage appears across each of the transistors
Question 19Single Answer
PAC stands for______.
  1. A
    Permanent angle converter
  2. B
    Phase angle converter
  3. C
    Phase angle components
  4. D
    Phase angle capacitor
  5. E
    None of these
Question 20Single Answer
For normal operation of a transistor
  1. A
    Forward bias the emitter diode and reverse bias the collector diode
  2. B
    Forward bias the emitter diode as well as the collector diode
  3. C
    Reverse bias the emitter diode as well as the collector diode
  4. D
    Reverse bias the emitter diode and forward bias the collector diode
Question 21Single Answer
Consider the following statements:
The output of a linear circuit, driven with a sine wave at a frequency f, is itself a sine wave
1. at the same frequency
2. with chance of changed amplitude
3. with chances of changed amplitude and phase
Which of the above statements is/are correct? 
  1. A
    1 and 2
  2. B
    1 only
  3. C
    1 and 3
  4. D
    2 only 
Question 22Single Answer
Consider the following statements:
The main contribution to photo conduction is by
1. the generation of electron and hole pair by a photon
2. a donor electron jumping into the conduction band because of a photon’s energy
3. a valence electron jumping into an acceptor state because of a photon’s energy Which of the above statements is/are correct? 
  1. A
    1 only
  2. B
    2 only
  3. C
    3 only
  4. D
    1, 2 and 3
Question 23Single Answer
Thermal runaway is not possible in FET because as the temperature of the FET increase
  1. A
    mobility decreases
  2. B
     trans-conductance increases
  3. C
    drain current increases
  4. D
    trans-conductance decreases
Question 24Single Answer
For the same network, with 6 V DC connected at port A, 1 Ω connected at port B draws 7/3 A. if 8 V DC is connected to port A, the open circuit voltage at port B is
  1. A
    6 V
  2. B
    7 V
  3. C
    8 V
  4. D
    9 V
Question 25Single Answer
A signal may have frequency components which lie in the range of 0.001 Hz to 10 Hz. Which one of the following types of couplings should be chosen in a multistage amplifier designed to amplify the signal? 
  1. A
    Capacitor coupling
  2. B
    Direct coupling
  3. C
    Transformer coupling
  4. D
    Double-tuned transformer coupling
Important Questions Package

Trade Apprentice Welder, electronics & Communication Trade Exam Online Question Bank Package

Buy Trade Apprentice Welder, electronics & Communication Trade Important Questions, MCQ, question answer in Hindi & English. It will help you to score high marks in Trade Apprentice Welder, electronics & Communication Trade question bank 2026 in Online, PDF & Print study material.

+ Free Monthly Current Affairs, GK & more PDF Download
Sr.Package NameAmount
1.Trade Apprentice Welder, Electronics & Communication Exam - English
Description : 1000 Question with Answer
₹181 [₹500]
2.Trade Apprentice Welder, Electronics & Communication Exam - Hindi
Description : 1000 Question with Answer
₹181 [₹500]
View More Questions
Back to Exam
Question for ट्रेड अपरेंटिस वेल्डर, इलेक्ट्रॉनिक्स एवं संचार 2026 - Quiz / Questions / MCQ - Toppersexam